Study the effects of reinforcing elements on the flank wear when milling Al۵۲۰-MMC
سال انتشار: 1401
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 108
متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
COMPOSIT08_057
تاریخ نمایه سازی: 24 بهمن 1401
چکیده مقاله:
Amongst commercial composites, special attention is paid to metal matrix composites (MMCs). According tothe literature, the fabrication process of such materials with additive particles is still the subject of additional studies.Furthermore, limited studies were reported on the effects of reinforcing elements on the machinability of Al-MMC.Therefore, the effects of reinforcing elements, including silicon carbide (SiC), bismuth (Bi), and tin (Sn) particles on the toolflank wear under lubricated and dry milling of Al۵۲۰-MMC are presented in this work. According to experimentalobservations, the use of Bi and Sn in the matrix structure of the work part led to an almost ۵۰% reduction in the toolflank wear when machining Al۵۲۰ + ۱۰% SiC. Despite the reinforcing elements used, higher flank wear was observedunder dry machining than those recorded in lubricated mode.
کلیدواژه ها:
نویسندگان
Mahmoud Alipour Sougavabar
Department of Mechanical Engineering, Iran University of Science and Technology, Tehran ۱۳۱۱۴-۱۶۸۴۶
Seyed Ali Niknam
Assistant Professor, Department of Mechanical Engineering, Iran University of Science and Technology, Tehran ۱۳۱۱۴-۱۶۸۴۶
Behnam Davoodi
Associate Professor, Department of Mechanical Engineering, Iran University of Science and Technology, Tehran ۱۳۱۱۴-۱۶۸۴۶